Use this window to view the properties of an export connector as set by the .inf file. You cannot edit the information presented in this window.

Name

Displays the name of the currently selected export connector.

Setup progID

Displays the name (ID) of the setup program for the export connector.

Setup version

Displays the version of the setup program for the export connector.

Export progID

Displays the name (ID) of the export program for the export connector.

Export version

Displays the version of the export program for the export connector.

eDocument file support

Displays the current setting for support for eDocuments. If non-image files are supported, this property will be set to “Yes,” otherwise it will be set to “No.” You can change this property by editing the .inf file.

Note Total Agility only supports one eDocument per document. For information on enabling eDocument export, see the "Configure an Export activity" section in TotalAgility help.

Remain loaded

Displays the current setting for loading the connector. If the connector is to remain loaded for future use, this property will be set to “Yes,” otherwise it will be set to “No.” You can change this property by editing the .inf file.

If you know that the connector will be used again, you may be able to increase performance by keeping the connector in memory. However, this increase in performance is specific to each connector. Some connectors may actually be slower. Do not set this to “Yes” unless you are sure your connector has been designed to take advantage of remaining in memory.

Original file name support

Displays the current setting for retaining the original name of image files (not including the path). If the original file names will be retained, this property will be set to “Yes,” otherwise it will be set to “No.” If the original file name is not retained, TotalAgility will assign a new name to the image file using sequential numbers.

Multiple instance support

Displays the current setting for allowing multiple instances of the Export service. If multiple instances are supported, this property will be set to “Yes,” otherwise it will be set to “No.” For more information on multiple Export service instances, see the "Support export vertical scaling" section under "Edit the TotalAgility configuration settings" in the Kofax TotalAgility Installation Guide.

Note If you have a connector installed in a Total Agility version prior to 7.3.1, some of these properties may not be correct after upgrading to 7.3.1 or later version. To resolve this, you must remove and then re-add the connector.