Preliminary Classification Testing
Using a document set that contains typical documents for your project, you can test your classification results. You can test a single document, a group of documents, or even folders.
Once you are happy with the classification results for your test documents, run a classification benchmark that identifies where you need to refine and improve your classification settings further.
You can perform preliminary classification testing by following these steps:
- Open the Documents window if it is not already open.
- If a different view is in use, switch to the List view .
-
Add or select the document set that contains
some test documents.
The document set expands so you can see its document subsets.
-
Select the document subset that contains the desired test
documents.
The test documents are displayed.
-
Select one or more documents in the
Documents window and then from the Ribbon
Process tab, select one of the following
options from the
Classify submenu:
-
Classify Selection
-
Classify Documents Recursive
A progress bar is displayed showing the classification progress.
-
- The results of this preliminary testing can be viewed in the Classification Results window.