Resize a Zone
If a zone is either too large or too small, you can resize it as needed. This means that you do not need to remove a zone if it is not the right size or in the correct location.
After adding a zone, you can resize it by following these steps:
- Open the locator properties.
-
Open the
reference document.
The Document Viewer (Zone Mode) window is displayed.
- On the toolbar, click Selection Mode .
- Select the zone you want to resize.
- Click on the sizing handles to resize it.
- Optionally, close the Document Viewer (Zone Mode).
- Click Close to close the locator properties window.
- Save the changes to your project.