Test Zones on the Reference Document
Within the Properties window of the zone, you can test your zone settings on the reference document to improve the quality of the later results. This preliminary test enables you to optimize general settings, along with Image Cleanup and anchoring.
You can test a zone on the reference document by following these steps:
- Open the locator properties.
-
Open the
reference document.
The Document Viewer (Zone Mode) window is displayed.
- On the Zones tab, select the zone you are testing.
-
Click
Properties
.
The Zone Properties window is displayed.
-
Test the zone.
You can check the accuracy of the result in the Recognition Test area.
- Optionally, edit the zone properties to improve the results.