Add a Manual Anchor
If your document requires a manual anchor so a zone is easily located, you can add one by following these steps:
- Open the locator properties.
-
Open the
reference document.
The Document Viewer (Zone Mode) window is displayed.
-
On the
Document Viewer (Zone
Mode) toolbar, click
Add Anchor
.
The cursor changes so that you can draw a zone.
-
Draw a zone around the anchor.
The Anchor Properties window is displayed.
-
Select an
Anchor type.
The properties are updated for the selected anchor type.
-
Configure the properties as required.
The anchor displayed in the Anchor Search Zone is updated as you change the properties.
- Click OK to save your settings.
- Optionally, close the Document Viewer (Zone Mode) window.
- Optionally, click Close to close the locator properties window.
- Save the changes to your project.