Map a Zone to an Anchor
For an anchor to be beneficial to an Advanced Zone Locator, the anchors must be mapped to a zone. This enables the anchor zone to act as a reference for another zone, improving the probability that the zone is properly extracted.
You can map a zone to an anchor by following these steps:
- Open the locator properties.
-
Open the
reference document.
The Document Viewer (Zone Mode) window is displayed.
- On the Zone Viewer toolbar, click Selection Mode .
-
Double-click the zone to map to an anchor, or right-click the zone
and then click
Properties.
The Zone Properties window is displayed.
- On the Zone Properties window, select the Anchors tab.
-
On the list of
Available Anchors, select the anchor to map
and click
Add.
The anchor is mapped to the zone and displayed in the list of Selected Anchors.
-
Click
Close to save your
settings.
The Zone Properties window is closed.
- Open a test document and click Test to test your settings.
- Optionally, click Close to close the locator properties window.
- Save the changes to your project.