Configure SP mode settings
This procedure describes how to configure Service Provider (SP) modes. The SP Mode
settings are normally configured by the Configure and Reboot
Action Action. You can configure settings manually when a device does
not allow DRS to configure SP Mode settings through the Action.
This procedure requires working in Service Mode, which is typically performed by a
Ricoh technician.
- On the Home screen, go to Printer (scroll screen) and press the Printer icon.
- Enter SOP Service Mode mode (press Reset, then 806182 and then press and hold C) to complete the succeeding steps.
- Press System SP to enter SP Mode (press 0 to change bit from 0 to 1, then # to save).
-
Press SP Direct.
- In SP Direct type 5401230 on keypad, then type #.
-
Set the LSB to 1 by pressing zero
0 (Note: Value of the bit at index 0 is
changed when pressing 0) on keypad in CAC
configuration.
The last digit should now be 1.As for MFP and MPC306/MPC406 devices: SP-5420 must be set to 1 for CAC (in order for copy to work) and 0 for none-CAC installation (in order for copy to track).
-
Type # to save your changes.
-
Go to User Management tab, set
Admin. Authentication to
On.
, and on the
-
Go to Custom Auth. tab, enable LDAP
authentication.
, and on the
The label LDAP authentication in step 8 will be changed to Custom authentication after the machine is rebooted. - Configure the LDAP server.
-
Enable Machine Action When Limit is Reached in
System Settings (Administration tools) by selecting
Stop Job or Finish Job and
Limit.
-
Enable the network by setting
.
-
Turn on Tracking Permission.
The authentication logic customization feature becomes valid when the following condition is satisfied.