This procedure describes how to configure Service Provider (SP) modes. The SP Mode settings are normally configured by the Configure and Reboot Action. You can use this procedure to configure settings manually when a device does not allow DRS to configure SP Mode settings through the Action.

1. On the Home screen, go to Printer (scroll screen) and press the Printer icon.
2. Enter SOP Service Mode. Contact your Ricoh support representative for instructions.
3. Press System Sp (press 0 to change bit from 0 to 1, then # to save).
4. Press SP Direct.

   

5. In SP Direct type 5401230, then type #.
6. Set the LSB to 1 by pressing zero 0 on the keypad in CAC configuration.
   The last two digits should now be 1.
7. Type # to save your changes.

   

8. Go to User Tools > Machine Features > System Settings > Administrator Tools > Administrator Authentication Management, and on the User Management tab, set Admin. Authentication to On.

   

9. Go to User Tools > Machine Features > System Settings > Administrator Tools > User Authentication Management Setting, and on the Custom Auth. tab, enable LDAP authentication.

   

   The label LDAP authentication in step 8 will be changed to Custom authentication after the machine is rebooted.
10. Configure the LDAP server.
11. Enable Machine action when limit is reached in System Settings (Administration tools).

    Set this to Stop Job or Finish Job and Limit.

    

12. Enable the network by setting User tools > Login > Exit > Screen Features > Interface Settings > Set to Machine Network.

    

The authentication logic customization feature becomes valid when the following condition is satisfied.
13. Turn on Tracking Permission.