› ControlSuite Clients › Unified Clients overview › Tungsten Unified Client for Fujifilm › Preparing for deployment › Card reader configuration › Configure internal card reader

Configure internal card reader

If you are using the Fujifilm ICCR-B Card Reader, verify that the following configuration is complete

  1. Open HID Omnikey 5x27 Reader Management page.
  2. Select the Keyboard Wedge tab.
  3. On the General Config tab, complete the following settings:
    1. Select Keyboard Wedge Enable.
    2. In the Output Type list, select Keyboard Wedge.
    3. Select Boot Interface.
    4. In the Card Out Event Keystrokes field, leave [ENTER] or leave it blank. This is the default value.
  4. On your device, turn off the IC card reader B USB Setup Plugin.