Make a Table Locator trainable
A Table Locator that uses automatic extraction can be defined as a trainable locator. Select "Enable training" from the Settings tab to enable this functionality and train the table layout. Similar to other trainable locators a training set is created using the Edit Document window.
You can either train against a document set or documents that are returned from production selected from the New Samples file list.
To reuse a training set for other projects you can create a knowledge base (*.kbtbl) for the specific training type from the Knowledge Base tab.
You can make a Table Locator trainable by following these steps:
- Open the locator properties.
- On the Settings tab, for the Detection mode, select Automatic.
- Select Enable training.
- Load a training document from a custom test set or the New Samples document set.
- To add a selected document to the Extraction training set using the Edit Document window, press F10.
-
Click
Configure Table Model and define the table layout as follows.
-
Draw the master item within the
Document Viewer, to define the line item template.
If needed, set additional options on the Master Item tab.
- Define the table columns on the Cells tab and draw an anchor, if needed.
-
Click
Test to test the configuration.
The Test Results Tab displays the extracted rows.
-
Draw the master item within the
Document Viewer, to define the line item template.
- Click Validate to check the document for any problems.
-
Add the document to the
Extraction Set.
The project is trained automatically.
- Open a test document and click Test to test your settings.
- Optionally, click Close to close the locator properties window.
- Save the changes to your project.