› KCM Installation Guide › Manual component installation › Adding a Contract Manager › Stopping Contract Manager

Stopping Contract Manager

This section describes how you can use the StopContractManager.exe tool to stop the Contract Manager in your installation.

StopContractManager.exe is a command-line tool intended stop all Windows services of the Contract Manager and set them to disabled.

Execution steps

To stop the Contract Manager, execute the following steps:

  1. Open the command line interface (CLI). It could be PowerShell or Command Prompt.

  2. In the CLI, navigate to the folder where the StopContractManager.exe is located.

  3. Call the StopContractManager.exe file .

    If everything is correct, the process will run without errors. You will be able to follow the it by reading the CLI output.